Your active trackers are listed below. Open one to edit details, share a read-only link, or remove it.
Enter the 15-digit IMEI from the tracker label (digits only, or with spaces/dashes). Only IMEIs that pass server validation and are allowed for your organisation can be registered.
Shown on the map pin and in your device list. You can add or edit these anytime after registration.
Short label for your records; shown on the tracker detail screen in the app.
Pick a vehicle and time range, then Load route to draw it on the map. Distance is an estimate from your GPS fixes (straight segments between points), not the vehicle odometer. Tap the orange line to see time, location, and basic details (ignition, voltage, speed) where available. Use Detect trips to split the route: Time between GPS records starts a new trip when the gap between two stored points is longer than the minutes you set; Ignition on → off uses the engine state (still uses the gap setting to split long stretches). Very short movements may be omitted from the trip list and CSV exports.
Add circular zones. Routine enter/exit alerts are sent to the mobile app as push notifications (not routine email or SMS). Set the centre by clicking the map, searching an address, or typing latitude and longitude. If a search result looks wrong, click the map or enter coordinates manually. Leave Device empty to apply the zone to all vehicles, or choose a single vehicle. Alerts follow the quiet hours you configure below unless you Arm geofence alerts (24/7) above. Standard: up to 2 zones. Pro / Fleet: up to 5 zones.
Use the email and password for your Supabase account.
Forgot password?
We’ll email a reset link. In Supabase → Authentication → URL configuration, allow this page as a redirect URL.